Glue Film Iron On Hot Melt Adhesive

From: £0.95

Glue Film

We recommend only using glue film with top quality and flat wood veneer.

This is essentially a hot melt EVA adhesive, supplied on thin film backing paper. Extremely convenient for veneering and where a thin coating of glue is required, especially onto MDF or plywood.

Also for use with plastics, foam, fabrics and leather. Can be cut using scissors or a craft knife.

Approximate thickness of the glue film (excludes backing paper): 0.14mm.

Our glue film is 105cm wide, so you’ll receive slightly over the full square metre, excludes off cuts and seconds.

It melts at a relatively low temperature of around 85°C to 90°C. Heat can be applied from an iron, hot air blower, heated press etc. Apply by either peeling off the paper and laying in position or tack into position by applying heat through the backing paper.

• View our Glue Film Heat Activated Guide here.
• This information is based on our experience. It is intended as a general guide and recommendation. It is not a warranty or specification. Before use, we advise customers test and determine that the material is suitable for their intended purpose.

Inlay Brass Strip Suppliers, Brass Rod, Brass Rod Suppliers, Brass Bar.